♦
  Home
♦
  Products
♦
  Enquiry
♦
  Contact Us
Compressor Spare Parts

  Products
 

Compressors Parts

:: CONNECTING  RODS :::

Connecting rods in MOC of Aluminium, Leaded bronze

1 ) Connecting rods are available in MOC of Aluminium, Leaded bronze, SG Iron& Forging.

2 ) All the Connecting rods are machined on both the sides. Centre distance between big end & small end is maintained for perfect straightness & perfect boring of big end & small end.

3 ) Big end & small end of connecting rods are perfectly bored so as to match original clearances with steel bush for Air cooled unit & aluminium / Bronze floating bushes for water cooled unit.

4 ) The above Connecting Rods are available ex-stock & ready for shipment in case of urgency.  

5 ) The forged connecting rods are drilled internally perfect to maintain lubrication &  oil pressure of unit.

::: CROSSHEAD / PIN X HEAD :::

 

Crossheads for watercooled unit.     Pin Cross Head

CROSSHEAD

These crossheads are used in watercooled unit. It is made of individual alluminium alloy casting. Our cross heads are fully machined with proper tolerance to maintain clearance between Crosshead and guide (Dist Piece). The crossheads are having fine pitch to match the thread with Piston rod.

PIN CROSSHEAD

The Pin crosshead is steel material, harden ground & hollow inside for proper oil pressure of unit. Both the end of pin is grooved for locking arrangement by retainer ring. Outer surface of pin is drilled on equal distance to match the hole with bronze X-head pin bush. Both the end are closed. One end by cap & the other by plug. It is so ground & perfect tolerance is maintained so as to slide feet in crosshead bore.

::: VALVE & VALVE PARTS :::

 
O Ring, Gasket, Oil Seals    Valve Spare Parts
  

 
CHANNEL VALVES
These are two types of channel valves, Rectangular & Round valves. Both type of valves are used in reciprocating type compressors. These valves are available for Lubricated & Non-lubricated type of units. Exclusive designs of Valve seat, Stop plate, Plate seat so that to maximum flow is utilized & perfect sealing ensured. Holder guide (metallic) are highest quality machined with OEM tolerance which can significantly improve life of the valves. Plate seat are of stainless steel, heat treated, perfectly micro finished on both the side and lapped.

FINGER VALVE / CONCENTRIC VALVE ASSEMBLY / VALVE PARTS
Concentric valves are ready for shipment. Valve seat , Stop plate and Valve bolts are matching with OEM specifications.

Valve plates are properly heat treated & Micro finished for leak proof valve assembly. Spring plates , Finger valves & spacer plates are also heat treated, ground and engineered to give best operating efficiency against High pressure & high temperature of unit.
  Back >>

Connecting rods Valve Plates