Automatic Control Panels, Control Panels For Firefighting Pumpsets, Control Panels For Pumping Automation, Dombivli, India



AUTOMATIC CONTROL PANELS FOR BOREWELL APPLICATIONS

These type of Panels are for Submersible pump sets that are used to pump the water from Openwell / Borewell to Overhead tanks.
» Prodless Logic - Does not require sensor into the Borewell
» Programmable Cyclic ON / OFF Timer for Auto Restart.
» Auto / Manual Operation modes.
» DOL / Start-Run Models for 1 Ph pumps from 0.5 HP to 2 HP
» DOL / Star-Delta Models for 3 Ph pumps upto 100 HP
» Motor protection against Single Phasing , Reverse Phasing, Low voltages , Overload , Dry Running of pump set.

AUTOMATIC CONTROL PANELS FOR TANK TO TANK APPLICATIONS

These type of Panels are for Monobloc / Mono-Submersible pumpsets that are used to pump the water from Ground Tank to Overhead tank.
» Monitoring of Water levels by SS Sensors
» Auto / Manual Operation modes.
» Automatic - Alternate operation of Multiple no of pumps in “ Working + Stand-by ” mode.
» Available in 1 Ph / 3 Ph supply pumpsets
» DOL / Star-Delta Models for 3 Ph pumps upto 250 HP
» Motor protection against Single Phasing , Reverse Phasing, Low voltages , Overload , Dry Running of pumpset.

AUTOMATIC CONTROL PANELS FOR DEWATERING APPLICATIONS
AUTOMATIC CONTROL PANELS FOR DEWATERING APPLICATIONS

Auto Control Panels for Dewatering / Sewage / Vertical Sump pumps that are used to pump the water out from Sumps.
» Monitoring of Water Levels by SS Sensors / Float Level Switch
» Automatic - Alternate & Simultaneous Operation.
» Auto / Manual Operation modes.
» Available in 1 Ph / 3 Ph supply pumpsets
» DOL / Star-Delta Models for 3 Ph pumps upto 200 HP
» High Winding Temperature , Mech Seal Failure trip facility
» Motor protection against Single Phasing , Reverse Phasing, Low voltages , Overload , Dry Running of pumpset.
» Optional IP - 55 Outdoor Enclosures
In case of 2 pumps being put to use,

a) Cyclic : (Automatic )

By default both the pumps are put to equal use. Having them alternating as “Standby & Working” every time an operation commences.

b) Alternate : ( Manual )

Here a user decides the frequency of a particular pump to remain as Active or Standby. User can change the setting to suit his requirement based on Time switch.
In case of starters being in use “Level Controllers” can be procured which in turn will operate N/V coil of the existing Starter. Level controllers are bereft of Meters and Starter component.


Automatic Control Panel for Fire Fighting pumpsets
Automatic Control Panel for Fire Fighting Pumpset

These type of Control Panels are used to keep the Fire-Fighting Pumps BATTLE - READY in case of Fire Breakout.

» Control Panel incorporating Hydrant / Sprinkler / Jockey / Booster
» Automatic Diesel Engine Starter + Battery Charger with protections
» SFU / MCCB / HRC Backup used as Incommer / Outgoer
» Audio / Visual Alarm when Hydrant goes ON
» BAS option incorporated in the Panel
» DOL / Star-Delta Models in 3 Ph pumpsets upto 400 HP
» Busbar system for Higher HP pumpsets 
 


>> Contact Us
Address
:
Bhagwan Patil Compound, Near G. R. Patil College, Behind. Anapurana Hotel, 
Kalyan - Shill Road,  Sonarpada, Dombivli (East) - 421203, Maharashtra, India.
Tel.
:
 (0251) 2870290 / 6517290
Fax No.
:
 (0251) 2870290
E - mail
:
Website
:
 www.neelelectronics.com

Home | Profile | Products | Contact Us

Designed & Hosted by : MID    Promoted by : GID